ProForm 250i Elliptical English Manual - Page 14

15. Attach the Tablet Holder (92) to the back of the Console (30) with four #8 x 15mm Screws (93); 15 start all of the Screws, and then tighten them. 92 93 30 16. Remove and discard the wire tie on the Main Wire (32). While a second person holds the Console (30) near the Upright (2), plug the Main Wire (32) and the Pulse Wire (31) into the matching receptacles on the back of the Console. The connectors on the Main Wire (32) and the Pulse Wire (31) should slide easily into the receptacles and snap into place. If a connector does not slide easily into a receptacle, turn the connector and try again. If you do not connect the connectors properly, the console may become damaged. Then, insert the excess wire into the Upright (2). Tip: Avoid pinching the wires. Attach the Console (30) to the Upright (2) with four M4 x 16mm Screws (56) start all of the Screws, and then tighten them. See step 5. Tighten the M10 x 53mm Screw (73), the M10 x 20mm Screw (74), and the M10 x 60mm Bolt (72). Then, press the Accessory Tray (50) into place. 16 30 Avoid pinching the wires 32 2 31 56 17. Make sure that all parts are properly tightened before you use the elliptical. Extra parts may be included. Place a mat beneath the elliptical to protect the floor. 14