ProForm 3.6 Treadmill Uk Manual - Page 10

9. Identify the Right Handrail (90), which has a large hole in the location shown. Hold the Right 9 Handrail near the Console (87). Next, insert the tie on the console wire into the large hole in the Right Handrail (90) and out of the top as shown. Insert the included plastic tie through the holes in the Right Handrail as shown. Make sure the plastic tie holds the console wire to the near side. Tighten the plastic tie. Attach the Right Handrail with two M4.2 x 19mm Screws (1). Make sure that no wires are pinched. Start both Screws before tightening them; do not overtighten the Screws. Remove the plastic tie. Attach the Left Handrail (not shown) to the Console (87) in the same way. Note: There are no wires on the left side of the Console. Tie 90 Plastic Tie 87 Console Wire 1 Large Hole 1 10. Hold the Pulse Support (109) near the Console Base (88). Conect the ground wire from the Console Base to the Console Ground Wire (115) from the Pulse Support. Set the Pulse Support on the Console Base and insert the ground wires into the Console Base. Make sure that no wires are pinched. Tighten two M4 x 20mm Screws (3) with two M4.2 Star Washers (70) into the Pulse Support (109). Tighten the four longer M4.2 x 16mm Screws (12) and the two M5 x 15mm Screws (64) from step 8 into the Pulse Support (109) and Console Base (88). Start all six Screws before tightening them. 10 70 3 12 12 88 12 64 3 109 70 64 115 Ground Wire 10