ProForm 325 Uk Manual - Page 6
Console Base Bolts 91 and Console Base Nuts
View all ProForm 325 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
3. Carefully rotate the Console Base (45) to the posi- 3 tion shown. Secure the Console Base with two Console Base Bolts (91), two Console Base Washers (90), and two Console Base Nuts (11) as shown. 11 90 45 91 91 90 11 Refer to the inset drawing. Tighten all four Console Base Bolts (91) and Console Base Nuts (11) as tightly as possible. Carefully lift up and push down on the handrails to make sure that the Console Base (45) does not move. Regularly inspect and tighten all four Console Base Bolts and Console Base Nuts. Handrails 45 11 91 91 11 4. Attach the Frame Guide (66) and the Frame Guide 4 Spacer (46) to the left side of the Frame (21) with two Guide Screws (25). Note: Be careful not to over- tighten the Guide Screws. Make sure that the thick end of the Frame Guide is at the bottom. 25 46 66 21 Thick end 5. Remove the backing from the Adhesive Clip (2). 5 Press the Adhesive Clip onto the base of the Upright (37) in the indicated location. Press the Allen Wrench (35) into the Adhesive Clip. 37 2 35 6. The Console (49) requires two "AA" batteries (not included); alkaline batteries are recommended. 6 Open the Battery Cover (48) as shown. Press two batteries into the battery compartment, with the negative ends of the batteries (marked ÒÐÓ) touching the springs. Close the Battery Cover. 49 48 7. Make sure that all parts are properly tightened before you use the treadmill. To protect the floor or carpet from damage, place a mat under the treadmill. 6 Batteries