ProForm 350s Crosstrainer Treadmill English Manual - Page 9

8. Insert the excess Wire Harness (42) into the large hole in the side of the Right Handrail (72). Securely tighten the plastic ties on the bottom of the Console Base (47) to prevent the Wire Harness from slipping. Then, cut off the ends of the plastic ties. Route the Wire Harness (42) through the indicated opening in the Console Base (47), and attach the Wire Cover (44) to the Console Base with a 1/2" Silver Screw (48). Do not overtighten the Silver Screw. Tighten a Crossbar Screw (39) into the bracket on each Upright (69) and into the Crossbar (40) (one one Screw is shown). 8 Ties Opening 47 42 44 72 40 69 48 39 9. Attach a Wheel (66) to the inner side of each Extension Leg (63) with a Wheel Bolt (64) and a Wheel Nut (32) 9 (only one Wheel is shown). Do not overtighten the Wheel Bolt. The Wheel should be able to spin freely. Lift the treadmill frame (see HOW TO FOLD THE TREADMILL FOR STORAGE on page 14), but do not latch it. Make sure that the frame is centered between the Handrails (not shown). See step 4 and firmly tighten the 3/4" Bolts (37). Then, lower the frame to the floor. 63 32 66 64 10.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the walking belt (see page 17). To protect the floor or carpet, place a mat under the treadmill. 9