ProForm 385ex Treadmill Canadian English Manual - Page 11

3. With the help of a second person, lift the right Handrail (2) off the right Upright (14). Hold the Console Base (6) and the Right Handrail in the position shown. Feed all of the excess Wire Harness (26) into the Right Handrail, through the indicated bracket, and down into the right Upright; bend the Wire Harness, if necessary. Cut the indicated plastic tie off the right Handrail (2). Make sure that the Wire Harness (26) is in the bracket and insert the bracket into the right Upright (14). Make sure that the Wire Harness is not pinched. 4. Thread a Handrail Bolt (15) with a Handrail Washer (16) into the right Upright (14) and the right Handrail (2). Do not tighten the Handrail Bolt yet. Make sure that the hole in the bracket on the Extension Leg (41) is aligned with the hole in the Handrail (2). Tighten an Extension Leg Screw (34) into the bracket and Handrail. 3 6 Bracket 2 Plastic Tie 26 14 4 15 16 2 14 5. Attach the Console Base (6) to the Handrails (2) with four 3/4" Screws (59). 5 Tighten all parts used in steps 2, 4, and 5. 2 6. Remove the backing from the Adhesive Clip (74). Press the Adhesive Clip onto the base of the Uprights (14) in 6 the indicated location. Press the Allen Wrench (73) into the Adhesive Clip. 7. Attach the Storage Latch (12) to the left Upright (14) with 7 two 1/2" Screws (13). Be careful not to overtighten the Screws. 8. Make sure that all parts are tight before you use the treadmill. (Note: The ratchet screws shown at the far right are factory set and should not be adjusted.) To protect the floor or carpet from damage, place a mat under the treadmill. 6 34 Bracket 41 6 59 2 59 14 73 74 8 14 12 13 Ratchet Screws