ProForm 400 Zlt Treadmill Uk Manual - Page 7
Bolts 5 and two 3/8 Star Washers 39
View all ProForm 400 Zlt Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
2. Orient the Left Upright (31) as shown, and at- 2 tach it to the Base (48) with two 3/8" x 2 1/4" Bolts (5) and two 3/8" Star Washers (39); do not tighten the Bolts yet. Make sure the top of the Left Upright is angled in the same di- rection as the top of the Right Upright (36). 36 48 31 39 39 5 3. Attach a Wheel (45) to each side of the Base (48) with a 3/8" x 2 1/4" Bolt (5), two Wheel Spacers (44), and a 3/8" Nut (47) as shown. Do not overtighten the Bolts; the Wheels should turn freely. 3 45 44 44 47 5 48 45 44 47 44 5 4. Raise the Uprights (31, 36) so that the Base (48) is flat on the floor and positioned as shown. Cut the tie holding the Upright Wire (28) in a bundle. See the far right drawing. Tie the wire tie in the Right Upright (36) around the end of the Upright Wire (28). Then, pull the other end of the wire tie until the Upright Wire is extending from the upper end of the Right Upright. Make sure that the end of the Upright Wire (28) does not fall into the Right Upright (36). 4 28 Wire Tie 31 36 36 Large 28 Hole Wire Tie 48 7