ProForm 415 Crosswalk Treadmill English Manual - Page 8

5. With the help of a second person, carefully tip the treadmill onto its right side. Partially fold the Frame (48) so the treadmill is more stable; do not fully fold the Frame yet. Remove and discard the two indicated bolts (A) and the shipping bracket (B). Attach a Base Pad (81) to the Base (85) in the location shown with a Base Pad Spacer (104) and an M4 x 25mm Screw (2). Then, attach another Base Pad with only a Screw. Remove the M10 Nut (33), the M10 x 50mm Bolt (27), and the shipping bracket (C) from the Base (85). Attach a Wheel (86) with the Bolt and the Nut that you just removed. Do not overtighten the Nut; the Wheel must turn freely. Discard the shipping bracket. 5 A 81 2 B 85 48 27 104 86 2 81 C 33 6. With the help of a second person, hold a Bolt Spacer (79) inside the lower end of the Left Upright (73). Insert a M10 x 96mm Bolt (5) with a M10 Star Washer (8) into the Left Upright and the Bolt Spacer. Repeat this step with a second Bolt Spacer, Bolt, and Star Washer. Orient the Left Upright (73) and the Left Upright Spacer (83) as shown. Hold the Left Upright Spacer and the Left Upright against the Base (85). Finger tighten the M10 x 96mm Bolts (5); do not fully tighten the Bolts yet. Press a Base Endcap (82) into the Base (85). With the help of a second person, tip the treadmill so that the Base (85) is flat on the floor. 6 5 8 79 79 82 85 73 83 Rounded Corner 7. Set the Console (87) face down on a soft surface to avoid scratching the Console. Identify the Right Handrail (90), which has a large hole in the location shown. Hold the Right Handrail near the Console. Attach the console ground wire to the Right Handrail with an M4 x 13mm Screw (3). Next, insert the console wire into the large hole in the Right Handrail (90) and out of the top as shown. attach the Right Handrail with three M4 x 19mm Screws (1). Make sure that no wires are pinched. Start all three Screws before tightening any of them; do not overtighten the Screws. Attach the Left Handrail (not shown) to the Console (87) in the same way. Note: There are no wires on the left side of the Console. 7 90 1 Console Ground Wire 3 87 8 Console Wire Large Hole 1