ProForm 420 Zle Instruction Manual - Page 9

6. While a second person holds the Upright (3) near the Base (1), connect the Upper Wire 6 Harness (48) to the Lower Wire Harness (49). Tip: Avoid pinching the wires. Insert the Upright (3) into the Base (1). Attach the Upright (3) with an M8 x 69mm Bolt (80), an M8 Split Washer (90), and an M8 Jam Nut (79). Do not tighten the Bolt yet; make sure that the Jam Nut is in the hexagonal hole in the Base. Next, finger tighten two M8 x 23mm Screws (84) and two M8 Split Washers (90) into the Base (1). Do not tighten the Screws yet. Attach the Water Bottle Holder (22) to the Base (1) with two M4 x 16mm Blunt Screws (104). 80 90 90 84 Avoid pinching the wires 3 48 49 79 90 84 104 22 1 7. Identify the Left Upright Cover (17) and hold it against the left side of the Upright (3). 7 Attach the Left Upright Cover (17) with two M4 x 16mm Round Head Screws (101). Attach the Right Upright Cover (39) in the same way. 17 101 3 39 101 9