ProForm 480 Cx Treadmill Uk Manual - Page 9

8. Hand tighten four additional Screws (3) into the 8 Handrail (20) and the console assembly. Then, tighten all nine Screws used in step 7 and this step; do not overtighten the Screws. Plug in the power cord as described on page 11, and turn on the power as described on page 13. Note: The treadmill may automatically rise to the maximum incline level and then return to the minimum level. Console Assembly 20 3 3 9. Attach the Latch Housing (73) to the left Upright 9 (84) with two Screws (3). Make sure that the large hole in the Latch Housing is on the side shown. Do not overtighten the Screws. If the pin is not preassembled in the Latch Housing (73), remove the knob from the pin. Make sure that the collar and the spring are on 73 the pin as shown. Insert the pin into the Latch Housing, and tighten the knob back onto the pin. Knob 3 Large Hole 84 Spring Collar Pin 10.Place the treadmill in the storage position (see 10 HOW TO FOLD AND MOVE THE TREADMILL on page 24). Next, place the cylinder end of the Shock (92) near the bracket on the base of the Uprights (84). See the two small inset drawings. Using your fingernail or the end of a screwdriver, press on the end of the Shock Pin (25) to loosen it from the Shock (92). Next, rotate the Shock Pin and pull it out of the Shock. Be careful to avoid losing the Shock Pin. 10a See drawing 10a. Press the cylinder end of the Shock (92) onto the ball on the bracket. Next, insert the end of the Shock Pin (25) through two of the small holes in the end of the Shock. Then, rotate the Shock Pin until it clips onto the Shock. 58 25 84 25 92 Bracket 25 Cylinder 25 92 Bracket 9