ProForm 480cx Uk Manual - Page 6

Handrail Bolt (20)-4 ASSEMBLY Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, wipe off the lubLra(ictXcaXhnXtS)wc-ri2tehwa soft cloth and a mild, non-abrasive cleaner. Assembly requires the included hex keys, your own phillips screwdriver ow3n/4r"uTbebkeSrcmreawlle(5t 8)-8 . Extension Leg Bolt (64)-4 , and your For help identifying the assembly hardware, see the drawings below. The number in parentheses below each drawing is the key number of the part, from the PART LIST on pages 30 and 31. The number following the parentheses is the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it has been pre-assembled. To avoid damaging plastic parts, do not use power tools for assembly. 1" Tek Screw (22)-4 Sliver Ground Screw (33)-1 Screw (3)-11 Star Washer (8)-8 1/4 Handrail Bolt/ Extension Leg Bolt (64)-8 H W 1. Make sure that the power cord is unplugged. 1 With the help of a second person, carefully tip the treadmill onto its left side as shown. Partially fold the Frame (58) so the treadmill is more sta- ble. Do not fully fold the treadmill until it is completely assembled. 89 77 Insert an Extension Leg (89) into the base of the Upright (84) as shown. Note: Be careful not to pinch the Upright Wire Harness (77) in the base of the Upright. To fully insert the Extension Leg, it may be necessary to tap on it with a mallet. Next, insert two Extension Leg Bolts (64) with Star Washers (8) into the bottom of the Extension Leg, and firmly tighten the Extension Leg Bolts. 8 64 58 6