ProForm 485pi English Manual - Page 6
two Small Screws 13.
View all ProForm 485pi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
3. Place the Console Base (46) on the tubes on the Uprights (11). Pull out the two Wires (21) just enough to connect them to the two connectors in the Console Base. Make a loop with the indicated plastic tie and insert the end through the tie holder on the bottom of the Console Base. Plug the Wire that has a red connector into the corresponding connector in the Console Base. The connectors should fit together without being forced; if they do not, rotate the red connector on the Wire and try again. Do not force the connectors together. Next, plug the other Wire into the other connector on the Console Base. Important: Make sure that both Wires are fully inserted. WARNING: Do not disconnect or connect the Wires while the treadmill power cord is plugged in. Pull the plastic tie tight and cut off the end. Refer to drawing 3b. Thread six Console Screws (88) into the Uprights (11) and the Console Base (46). After all six Console Screws have been started, tighten the Screws until they are snug. Do not overtighten the Screws. 4. Attach the Storage Latch (14) to the left Upright (11) with two Small Screws (13). Be careful not to overtighten the Screws. 3a 46 21 11 21 Tie 3b 46 11 11 88 88 88 4 14 13 11 5. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill. 6