ProForm 510i Treadmill User Manual - Page 8
Console May Be Damaged When
View all ProForm 510i Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
5. Insert the tab on one of the Handrail Brackets (5) into the slot in the right Upright (69). Attach the 5 Handrail Bracket with a 3/4" Screw (2). Attach the other Handrail Bracket to the left Upright (not shown) in the same way. 69 Slot 5 2 6. Set the Console (43) face-down on a soft surface to avoid scratching the Console. Next, hold 6 a Handrail (71) near the Console. Insert the con- sole wire into the hole in the side of the Handrail and out of the hole in the top as shown. Then, attach the ground wire to the Handrail with a Silver Ground Screw (96). 2 71 2 Set the Handrail (71) on the Console (43). 2 Attach the Handrail with three 3/4" Screws (2). Console Wire Make sure that the console wire is not pinched. Start all three Screws before tight- Ground Wire ening any of them; do not overtighten the Screws. Insert the excess ground wire back into the opening in the Console. 43 96 Attach the other Handrail (not shown) to the Console (43) as described above. Note: There are no wires on the other side. 7. Remove the tie holding the Wire Harness (42) to the right Upright (69). With the help of a second person, hold the Console (43) near the right Upright. Connect the Wire Harness (42) to the console wire. Make sure to connect the connectors properly (see the inset drawing). The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Then, insert the connectors and the excess wire into the right Upright (69). 7 43 42 69 Console Wire Console Wire 42 8