ProForm 520i Treadmill English Manual - Page 8

8. Attach the matching Left Bottom Handgrip (82) with three 8 1/2" Screws (33). Attach the Right Top Handgrip and the Right Bottom Handgrip (not shown) as described above. 82 33 9. Attach a Wheel (58) to the right side of the Base (116) with a Wheel Bolt (56) and a Nut (3) as shown. 9 Attach a Wheel to the left side of the Base (not shown) in the same way. 3 58 116 56 10. Carefully lower the Uprights (55, 64) as shown. Press the Console Back (40) onto the back of the Console Base (38). Make sure that the Console Back and Console Base are mated correctly and that no wires are pinched. Tighten two 1/2" Silver Screws (114) into the indicated holes. Tighten 3/4" Screws (37) into the other holes in the Console Back. Make sure that the Left Upright (64) is flush with the left side of the Base (116). Firmly tighten, but do not overtighten, the two Upright Bolts (112) in the left side of the Base. Then, make sure that the Right Upright (55) is flush with the right side of the Base. Tighten the two Upright Bolts (not shown) in the right side of the Base. Insert the Left and Right Cup Holders (39, 50) into the large holes in the Console Base (38). If there is a small hole under each Cup Holder, the two Small Clamps (117) need to be attached. Refer to the inset drawing. Loop a Small Clamp through the hole in the bottom of a Cup Holder and attach it with a 3/4" Screw (37). Attach a Small Clamp to the other Cup Holder in the same manner. Raise the Uprights (55, 64) to the vertical position. 10 114 39 40 37 114 50 38 55 64 37 112 117 116 11.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 25). Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.To protect the floor or carpet from damage, place a mat under the treadmill. 8