ProForm 525 Treadmill English Manual - Page 11
Make sure that no wires are pinched. - belt adjustment
View all ProForm 525 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
14. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the large hex key is used to adjust the walking belt (see page 23). If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the receiver included with the chest pulse sensor. 1. Remove the key from the console and unplug the power cord. Remove the 3/4" Screw (23) and the Access Door (100) from the back of the Console Base (98). Wire 2. Connect the wire on the receiver (A) to the indicated wire extending from the Console Base (98). Hold the receiver so the small cylinder is oriented as shown and is facing the Console Base. Attach the receiver to the plastic posts on the Access Door (100) with the two included small screws. 3. Make sure that no wires are pinched. Reattach the Access Door (100) with the 3/4" Screw (23). Discard the other wires included with the receiver. 98 100 23 Small Screws A Small Cylinder 11