ProForm 525 User Manual - Page 8
Caution - treadmill key
View all ProForm 525 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Speed Control Monitor Display Pulse Display On/Reset Display Button Button Pulse Sensor Key Clip CAUTION: Before operating the console, read the following precautions. • Do not stand on the walking belt when turning on the power. • Always wear the clip (see the drawing above) whilst operating the treadmill. When the key is removed from the console, the walking belt will stop. • Adjust the speed in small increments. • To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and use only a sealable water bottle. BATTERY INSTALLATION UNPLUG THE POWER CORD. The console re- Batteries quires two 1.5 V batteries (in- cluded). Alkaline batteries are rec- ommended. To in- Cover stall batteries, first open the battery cover under the console as shown. Press two batteries into the battery compartment. Make sure that the neg- ative (-) ends of the batteries are touching the springs. Close the battery cover. STEP-BY-STEP CONSOLE OPERATION If there is a thin sheet of clear plastic on the console, remove it. In addition, make sure that the power cord is properly plugged in (see page 7). Next, step onto the foot rails of the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothes. Fully insert the key into the console. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip as needed. Then, remove the key from the console. Follow the steps below to operate the console. 1 Insert the key fully into the console. Inserting the key will not turn on the displays. The displays will turn on when the ON/RESET button is pressed or when the walking belt is started. Note: If you just installed batteries, the displays will already be on. 2 Reset the speed control and start the walking belt. Slide the speed control to the RESET position. Note: Each time the walking belt is stopped, the speed control must be moved to the RESET position before the walking belt can be restarted. 8