ProForm 530 Treadmill English Manual - Page 8
Firmly tighten the Pulse Bar Screws. Be careful
View all ProForm 530 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
5. Turn the Console (88) upside-down; be careful not to scratch the Console. Remove the bands and the Console 5 Back (95) (see drawing 6) from the Console. If the four Pulse Bar Screws (68) (only two are shown) are in the Console Frame (7), remove them. Hold the ends of the Pulse Bar (110) against the Console Frame (7) as shown. Connect the pulse wire in the Console (88) to the pulse wire in the Pulse Bar (see the inset drawing). The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try again to connect them. Attach the Pulse Bar to the Console Frame with the four Pulse Bar Screws (68). Firmly tighten the Pulse Bar Screws. Be careful not to damage the wires. Attach the ring on the ground wire to the Console Frame (7) with a 1/2" Ground Screw (114). Note: There are no wires on the other side of the Pulse Bar (110). 110 88 68 114 7 Pulse Wire Ground Wire Pulse Wire 6. Attach the Console Back (95) to the console assembly with five 3/4" Screws (6). 6 Console Assembly 6 6 95 7. With the help of another person, hold the console assembly near the Right Upright (82) and the left Upright (not shown). Connect the Wire Harness (83) to the wire harness in the console assembly. Make sure to connect the connectors properly (see the inset drawing); the connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try to connect them again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Insert the excess wire harness back into the right handrail. Set the console assembly on the Right Upright (82) and the Left Upright (not shown). Thread two 1/4" x 1" Bolts (71) with 1/4" Star Washers (92) into each side of the console assembly. After you have started all four Bolts, tighten them. 8 7 Console Assembly 83 Right Handrail 83 6 92 71 82