ProForm 540 S Treadmill English Manual - Page 7
Nected Properly, The Console May Be Dam
View all ProForm 540 S Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
2. Remove the screws and the wood brace from the Uprights (109). Discard the screws and the brace. Identify the left handrail, which has a hole in the indicated location, and the right handrail. Hold the right handrail near the right Upright (109), and insert the Wire Harness (83) into the large hole in the right handrail and out of the upper end as shown. Next, hold the right handrail against the right Upright (109). Tighten a 4" Bolt (112) three to four turns into the right Upright and the lower end of the right handrail. Tighten two 5/16" x 1" Bolts (122) into the upper end of the right handrail and the right Upright. Be careful not to drop the Bolts into the handrail. If necessary, raise or lower the handrail to thread the 5/16" x 1" Bolts into the right Upright. Firmly tighten all three Bolts. Attach the left handrail as described above. Note: There is not a wire harness in the left Upright (109). 2 122 Left Handrail Hole Brace Screw 109 83 122 Right Handrail Screw 112 109 112 3. With the help of another person, hold the console assembly near the right Upright (109) and the left Upright 3 (not shown). Connect the Wire Harness (83) to the wire harness on the console assembly. Make sure to connect the connectors properly (see the inset drawing); the connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and then try to connect them. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Insert the excess wire harness back into the right handrail. Console Assembly 83 Right Handrail Set the console assembly on the right Upright (109) and the Left Upright (not shown). Thread two 1/4" x 1" Bolts (71) with 1/4" Star Washers (92) into each side of the console assembly. After you have started all four Bolts, tighten them. 109 92 71 83 7