ProForm 540 English Manual - Page 7

2. Have a second person hold the Base (52) in the position shown. Identify the Left Upright (53) (the Right Upright [54] has a large hole near the lower end). Hold the Left Upright (53) so that the two small holes are on top as shown. Insert two Upright Bolts (2) with two Upright Washers (14) into the base of the Left Upright. Attach the Left Upright to the Base (52) with the Upright Bolts, two Upright Star Washers (9), and two Nuts (16). Do not tighten the Nuts yet. Attach the Right Upright (54) to the Base (52) in the same way. 2 2 14 54 Large Hole Small Holes 9 16 9 52 14 2 53 9 16 9 3. Slide the two Wheel Housings (45) onto the Base (52). Attach each Wheel Housing with two Wheel Housing Bolts (13), two Wheel Housing Washers (32), and two Wheel Housing Nuts (43). 3 32 45 43 13 32 32 45 43 13 32 52 4. Position the Base (52) as close to the front of the treadmill as possible, as shown. See drawing 4a. Locate the strap in the lower end of the Right Upright (54). Wrap the strap around the Wire Harness (39) and secure the strap using the included plastic tie. Then, insert the connector into the square hole in the Right Upright. Pull the opposite end of the strap until the end of the Wire Harness is pulled through the Right Upright. See drawing 4b. Press the indicated Grommet (49) into the Right Upright (54). 4 Strap 52 4a 54 Strap 39 54 Tie 4b 39 54 49 39 52 7