ProForm 600 Zne Elliptical English Manual - Page 7
Tip: To prevent the Main Wire 60
View all ProForm 600 Zne Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3. Identify and orient the Upright (5) and the Top Cover (27) as shown. 3 Slide the Top Cover (27) upward onto the Upright (5). Then, have a second person hold the Upright (5) and the Top Cover (27) near the Main Frame (1) until step 4. Locate the wire tie in the Upright (5). Tie the lower end of the wire tie to the Main Wire (60). Next, pull the upper end of the wire tie until the Main Wire is routed completely through the Upright. Tip: To prevent the Main Wire (60) from falling into the Upright (5), secure the Main Wire with the wire tie. Wire Tie 60 1 5 27 Wire Tie 4. Tip: Avoid pinching the Main Wire (60). Insert the Upright (5) into the Main Frame (1). 4 Attach the Upright (5) with four M8 x 16mm Patch Screws (102) and four M8 Split Washers (103); do not tighten the Patch Screws yet. You will tighten the Patch Screws at the end of step 11. 5 103 102 1 Avoid pinching the Main Wire (60) 102 103 103 102 103 102 7