ProForm 605 Hr Elliptical English Manual - Page 6

5. The Console (5) requires four 1.5V "D" batteries; alkaline batteries are recommended. See the inset drawing. Press the tab on the battery cover, and and remove it. Insert four batteries into the battery compartment. Make sure that the batteries are turned as shown by the diagram in the battery compartment. Reattach the battery cover. Whilst another person holds the Console (5) in the position shown, connect the wire harness on the Console to the Upper Wire Harness (86). Insert the excess wire harness into the Upright (2). Next, attach the Console to the Upright with three M10 x 27mm Button Screws (71) and three M10 Split Washers (70). Be careful to avoid pinching the wire harnesses. Snap the bookrack onto the Console (5). 6. Identify the Left Handlebar (9), which is marked with a sticker. Insert the Left Handlebar into one of the Handlebar Legs (79); make sure that the Handlebar Leg is turned so the hexagonal holes are on the indicated side. Attach the Left Handlebar to the Handlebar Leg with two M8 x 45mm Button Bolts (50) and two M8 Nylon Locknuts (46). Make sure that the Nylon Locknuts are inside of the hexagonal holes. Do not fully tighten the Button Bolts yet. Apply a generous amount of the included grease to the Pivot Axle (93) and to the two M8.5 Washers (53). Next, insert the Pivot Axle into the Upright (2) and centre it. Reapply grease to both ends of the Pivot Axle. Slide a Handlebar Spacer (25) onto the short tube on the Left Handlebar (9), and rotate the Handlebar Spacer so the small arrow is pointing toward the floor. Next, slide the Left Handlebar onto the left end of the Pivot Axle (93). Finger tighten an M8 x 25mm Patch Screw (22) with an M8.5 Washer (53) and a Wave Washer (94) into the end of the Pivot Axle. Then, press the small tabs on a Handlebar Cap (23) into the Handlebar Spacer. Assemble the Right Handlebar (not shown) and the other Handlebar Leg (not shown) in the same way. Then, tighten both M8 x 25mm Patch Screws (22). 7. Hold the lower end of the left Handlebar Leg (79) inside of the left Front Spring Bracket (17). Apply a generous amount of grease to an M10 x 78mm Button Bolt (27). Attach the left Handlebar Leg to the left Front Spring Bracket (17) with the Button Bolt, two M10 Washers (38), and an M10 Nylon Locknut (29). Do not overtighten the Nylon Locknut; the left Handlebar Leg must be able to pivot freely. Attach the right Handlebar Leg (79) to the right Front Spring Bracket (17) in the same way. 5 Bookrack 5 Tab Battery Cover Batteries Wire Harness 86 71 70 71 5 2 71 70 6 Grease 93 9 2 53 25 22 Arrow 95 46 23 50 Hexagonal Holes 79 7 79 29 38 38 27 17 Grease 79 17 6