ProForm 675 Crosstrainer Treadmill English Manual - Page 7

2. Attach a Wheel (66) to the base of the Uprights (69) with a Wheel Bolt (64) and a Nut (13) as 2 shown. Do not overtighten the Wheel Bolt; the Wheel should turn freely. 64 69 66 13 3. With the help of a second person, carefully tip the treadmill onto its right side as shown. Partially fold the Frame (86) so the treadmill is more stable. Do not fully fold the treadmill until it is completely assembled. Insert an Extension Leg (63) into the base of the Uprights (69). Hold an Extension Leg Nut (46) in the bottom of the Extension Leg, and thread a Extension Leg Bolt (93) with a Star Washer (95) into the top of the Extension Leg. Next, thread a 3" Bolt (96) with a Star Washer into the bottom of the Extension leg. Firmly tighten the Bolts. Attach two Base Pads (57) to the base of the Uprights (69) with two 1" Tek Screws (39). Attach the other Wheel (66) to the base of the Uprights (69) with a Wheel Bolt (64) and a Nut (13). Do not overtighten the Wheel Bolt; the Wheel should turn freely. 3 66 64 86 69 13 39 57 57 39 96 95 46 63 93 95 4. If there is a board (not shown) between the Uprights (69), remove the two bolts attaching the board. Discard the board and the bolts. Remove the tie from the Wire Harness (42). Hold one of the Handrails (71) near the right Upright (69), and insert the Wire Harness into the opening in the bottom of the Handrail and out of the indicated hole in the top. 4 93 95 Set the Handrail (71) on the right Upright (69), and tighten two Handrail Bolts (93) with two Handrail Star Washers (95) into the Handrail and the right Upright. Make sure that the Wire Harness (42) is not pinched. Attach the other Handrail (71) to the left Upright (69) as described above. Note: There is not a wire harness on the left side. 7 71 42 69 93 95 71 69