ProForm 675 E Treadmill English Manual - Page 11

10. Remove the plastic ties from the Right Handrail (90) and the Left Handrail (not shown). If necessary, press the Cage Nuts (38) into place. Have a second person hold the console assembly near the Right Upright (78). Connect the Upright Wire (77) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Remove the long tie from the Upright Wire and the tie from the console wire. Then, insert the connectors into the Right Upright (78). Set the console assembly on the Right Upright (78) and the Left Upright (not shown). Make sure that no wires are pinched. 10 38 Plastic Ties 77 78 Console Assembly 90 Console Wire Console Wire 77 Long Tie 11. Tighten four M8 x 25mm Bolts (6) with four M8 Star Washers (10) into the Uprights (73, 78) and the Handrails (89, 90). Start all four Bolts before tightening any of them. See steps 4 and 6. Tighten the M10 x 96mm Bolts (5). Press the Left Accessory Tray (110) and the Right Accessory Tray (111) into the Console Base (88). 11 110 111 88 89 6 10 6 10 73 90 6 10 10 6 78 11