ProForm 700 Gx Treadmill English Manual - Page 8

5. See the inset drawing. Make sure that there are two Unuts (112) in the upper end of each Upright (119, 111). Note: Extra U-nuts may be included. Identify the right and left Handrails (108); there is an identification sticker on each Handrail. Hold the right Handrail near the Right Upright (119). Insert the Wire Harness (118) into the large hole in the right Handrail and out of the upper end as shown. Next, hold the right Handrail (108) against the Right Upright (119). Tighten a 3/8" x 3 1/2" Bolt (121) three to four turns into the Right Upright and the lower end of the right Handrail. Then, tighten two 5/16" x 1" Bolts (113) into the upper end of the right Handrail and the Right Upright. Be careful not to drop the Bolts into the right Handrail. If necessary, raise or lower the right Handrail to thread the Bolts into the Right Upright. Firmly tighten all three Bolts. Attach the left Handrail (108) to the Left Upright (111) as described above. Note: There is not a wire harness in the Left Upright. 5 113 108 119 112 111 118 113 121 108 119 121 6. See the inset drawing. Turn the Console (101) upsidedown on a soft surface. Remove the packing bands and the Console Back. If there are two Pulse Bar Screws (76) in each end of the Console Frame (80), remove them. Hold the ends of the Pulse Bar (77) against the Console Frame, and attach the Pulse Bar with the four Pulse Bar Screws. Firmly tighten the Pulse Bar Screws. Be careful not to damage any wires. Locate the pulse wire extending from the Pulse Bar (77). Insert the pulse wire under the Console Frame (80) and plug the pulse wire into the indicated connector. The pulse wire should slide easily into the connector and snap into place; if it does not, turn the pulse wire and then plug it in. Attach the indicated ground wires to the Console Frame (80) with a 1/2" Screw (52). 6 52 76 77 80 101 Ground Wires Pulse Wire Connector 104 101 7. Attach the Console Back (104) to the console assembly with five 3/4" Screws (33). Be careful not to pinch any wires. 7 33 33 104 33 Console Assembly 8