ProForm 720 Treadmill English Manual - Page 6
Tek Screw without the Base Pad first. Note: The indi - used
View all ProForm 720 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
2. With the help of a second person, carefully tip the Upright Base (97) down as shown. (Note: It may be helpful to place your foot on one of the Extension Legs [92] as you tip the Uprights.) Make sure that the Extension Legs remain in the Uprights. Attach each Extension Leg (92) with four 1" Tek Screws (80) and two Base Pads (99) as shown. Tighten the 1" Tek Screw without the Base Pad first. Note: The indicated center holes are not used. Attach the other two Base Pads (99) to the Upright Base (97) in the locations shown with two 1" Tek Screws (80). With the help of a second person, raise the Upright Base (97) to the vertical position. 2 99 99 97 Not Used 80 99 Not Used 97 92 80 92 80 99 80 80 3. Remove the Latch Knob (88) from the Latch Pin (84). Make sure that the Latch Pin Collar (56) and the Spring 3 (34) are on the Latch Pin. (Note: If there are two Latch Pin Collars, place one on each side of the Spring.) Insert the Latch Pin into the Latch Housing (82) and tighten the Latch Knob onto the Latch Pin. 88 82 34 56 84 4. See drawing 4c. With the help of a second person, hold the Console Base (101) near the Uprights (80, 84). Look under the Console Base and locate the wires on the sides of the Console Base. Make sure that the wires are not routed through the openings for the Trays (109, 111). Drawing 4a shows the correct route for the wires. Drawing 4b shows an incorrect route. See drawing 4c. Cut the plastic ties holding the Wire Harness (74) and the pulse wire in the Uprights (80, 84). Locate the Wire Harness (74) and the pulse wire in the Uprights (80, 84). Connect the Wire Harness and the pulse wire to the connectors on the sides of the Console Base (101). Make sure to connect the connectors properly (see the inset drawings). IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn a connector and try to insert it again. Insert the excess Wire Harness and pulse wire up into the Console Base. 6 4a 4b Correct 4c 111 Incorrect 109 101 74 80 84 Pulse 74 Wire