ProForm 740 Cs Treadmill English Manual - Page 7
Rear Foot without the Rear Foot Spacer. Hold the tread - belt adjustment
View all ProForm 740 Cs Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
4. Insert a Handrail Extension (85) into the left post as shown. Align the holes in the Handrail Extension with the holes in the post. If necessary, tap the Handrail Extension with a rubber mallet to fully insert it. Next, attach the Handrail Extension by tightening three Small Screws (76) into the indicated holes. Note that the hole in the left side of the post is not used. Note: If there is only one hole in the top of the post, tighten the third Small Screw into the hole in the left side of the post. Identify the Left Foam Grip (110), which has a large cutout in the right side. Slide the Left Foam Grip as far as possible onto the post on the left Upright (82). It may be helpful to apply soapy water to the Handrail Extension (85). 5. Make sure that the front edge of the Left Foam Grip (110) is under the Console Base (87) as shown. Tighten a Small Screw (76) into the side of the Left Foam Grip as shown. Attach the Right Foam Grip (not shown) and the other Handrail Extension (not shown) as described in step 4 and this step. There may be extra screws after assembly is completed. 4 Cutout 110 76 Post 85 76 82 76 5 87 76 110 76 6. Refer to drawing 6a. Locate the left Rear Foot (59) on 6a the treadmill. If the left Rear Foot touches the floor, go to step 7. If there is a space between the left Rear Foot and the floor, follow the instructions below. Hold the treadmill firmly with both hands, and raise the treadmill to the storage position as described on page 19. 59 Refer to drawing 6b. Using a phillips screwdriver, remove the Screw (60), the right Rear Foot (59), and the Rear Foot Spacer (11) from the treadmill. Reattach the right Rear Foot without the Rear Foot Spacer. Hold the treadmill with both hands, and lower the treadmill as described on page 19. Check the left Rear Foot (59 [see drawing 6a]). If the left Rear Foot is still off the floor, raise the treadmill and remove the left Rear Foot. Snap the Rear Foot Spacer (11) onto the left Rear Foot and reattach the left Rear Foot and the Rear Foot Spacer. Carefully lower the treadmill. 6b 60 59 11 7. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 21). To protect the floor or carpet from damage, place a mat under the treadmill. 7