ProForm 750 Cardio Cross Trainer English Manual - Page 8

9. Apply a small amount of grease to the axle on the left 9 Disc Crossbar (16). Slide a Spring Spacer (63) onto the axle; make sure that the Spring Spacer is turned so the flat side is facing the elliptical crosstrainer. Grease Next, slide the Left Rear Spring Bracket (12) on the left Pedal Spring (11) onto the axle. Slide a Spring Bracket 16 Washer (35) onto an M10 x 27mm Patch Screw (40), and tighten the Patch Screw into the axle. 11 63 12 2 Next, hold the lower end of the left Handlebar Leg (5) inside of the Front Spring Bracket (73) on the left Pedal 40 35 7 Spring (11). Apply grease to an M10 Bolt Set (74). Attach the Handlebar Leg to the Front Spring Bracket with the Bolt Set. Do not overtighten the Bolt Set; 5 the Handlebar Leg must pivot freely. Attach the right Pedal Spring (not shown) to the right side of the elliptical crosstrainer in the same way. Tighten the two M10 x 74mm Button Bolts (7). Refer to step 7. Tighten the M8 x 45mm Button Bolts (50) in the Handlebar Legs (5). 73 74 Grease 74 11 10. Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical crosstrainer. 8