ProForm 775treadmill English Manual - Page 9
Remove the Screw 3 and the Access Door - belt
View all ProForm 775treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
8. Set the console assembly on the Handrail (20). Be careful not to pinch any of the wires. Make sure that the ground wire (see step 6) and the wire harness from the console assembly (see step 7) are in the indicated channel. Partially tighten five Screws (3) into the Handrail (20) and the console assembly. Start all five Screws, but do not tighten them yet. Do not put Screws into the two indicated holes. 8 Channel Console Assembly 3 20 3 3 No Screws 9. Partially tighten four additional Screws (3) into the Handrail (20) and the console assembly. 9 Then, tighten all nine Screws used in step 8 and this step; do not overtighten the Screws. Console Assembly 20 3 3 10. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the large hex key is used to adjust the walking belt (see pages 22 and 23). If you purchase the optional chest pulse sensor (see page 18), follow the steps below to install the receiver included with the chest pulse sensor. 1. Remove the key from the console and un- plug the power cord. 85 Remove the Screw (3) and the Access Door (76) from the back of the Console Base (85). 2. Connect the wire on the receiver to the indicated wire extending from the Console Base (85). Hold the receiver so the antenna is oriented as shown and is facing the Console Base. Attach the receiver to the plastic posts on the Access Door (76) with the two included small screws. 3. Make sure that no wires are pinched. Reattach the Access Door (76) with the Screw (3). Discard the other wires included with the receiver. 9 Small Screws Receiver Antenna Wires 76 3