ProForm 785 F Elliptical English Manual - Page 6

Attach the Front Stabilizer 6 to the Frame 1 - elliptical

Page 6 highlights

1. To make assembly easier, read the 1 information on page 5 before you begin assembling the elliptical exerciser. Attach the Front Stabilizer (6) to the Frame (1) with two M8 x 80mm Patch Screws (84). 6 84 2. Orient the Ramp (3) as shown. Then, insert the 2 Ramp into the Frame (1). Attach the Ramp (3) with five M8 x 19mm Patch Screws (82) and five M8 Split Washers (83). 1 82 83 1 3 83 83 82 82 3. While a second person holds the Upright (4) near the Frame (1), connect the Upper Wire 3 Harness (110) to the Lower Wire Harness (111). Tip: Avoid pinching the wires. Slide the Upright (4) onto the Frame (1). Attach the Upright with four M8 x 19mm Patch Screws (82) and four M8 Split Washers (83). Do not tighten the Patch Screws yet. Avoid pinching the wires 4 82 83 82 110 111 83 82 1 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

6
1.
Attach the Front Stabilizer (6) to the Frame (1)
with two M8 x 80mm Patch Screws (84).
2.
Orient the Ramp (3) as shown. Then, insert the
Ramp into the Frame (1).
Attach the Ramp (3) with five M8 x 19mm Patch
Screws (82) and five M8 Split Washers (83).
1
2
84
1
1
3
6
To make assembly easier, read the
information on page 5 before you begin
assembling the elliptical exerciser.
83
83
83
82
82
82
3.
While a second person holds the Upright (4)
near the Frame (1), connect the Upper Wire
Harness (110) to the Lower Wire Harness (111).
Tip: Avoid pinching the wires.
Slide the
Upright (4) onto the Frame (1). Attach the
Upright with four M8 x 19mm Patch Screws (82)
and four M8 Split Washers (83).
Do not tighten
the Patch Screws yet.
3
Avoid pinching
the wires
1
82
82
82
83
83
4
110
111