ProForm 785 Ss English Manual - Page 6

ASSEMBLY Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench and your own phillips screwdriver and rubber mallet . Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. 1. With the help of a second person, carefully raise the treadmill to the upright position as shown at the right. 1 While a second person tips the treadmill to one side and holds it, insert one of the Extension Legs (102) into the treadmill as shown. Make sure that the Extension Leg is turned so the Base Pad (99) is on the bottom. Next, tip the treadmill to the other side and insert the other Extension Leg (not shown) in the same way. Lower the side of the treadmill so that both Extension Legs (102) are resting flat on the floor. 102 99 2. With the help of a second person, carefully lower the treadmill frame and then tip the Uprights (69) down as shown. Make sure that the Extension Legs (102) remain in the Uprights. Attach each Extension Leg (102) with two of the four 3/4" Screws (100) as shown. With the help of a second person, carefully tip the Uprights (69) back to the vertical position. Note: One replacement Base Pad (99) may be included. Use the extra Base Pad if one becomes worn or needs to be replaced. 2 69 99 99 Frame 100 102 69 100 102 3. Insert the Handrail Extension (66) into the post on the right Upright (69) as shown. Make sure that the indicated holes are on top. Tap the Handrail Extension with a rubber mallet to fully insert it. Attach the Handrail Extension with two 1/2" Screws (67) as shown. Identify the Right Foam Grip (75), which has a large cutout in the left side for the Pulse Bar (76). Slide the Right Foam Grip as far as possible onto the post on the right Upright (69). Make sure that the tab on the Foam Grip inserts into the Console Base (81). Note: It may be helpful to use soapy water on the Handrail Extension (66). 3 Tab 76 67 Cutout Holes 75 66 81 69 Post 6