ProForm 790 Uk Manual - Page 6

2. Refer to drawing 2a. Locate the sheath and make sure that it remains on the Cable Connector (43). Insert the tip of the Upper Resistance Cable (6) into the opening in the Cable Connector as shown in the inset drawing. Pull up on the Upper Resistance Cable and insert it into the top of the Cable Connector. Center the sheath on the Cable Connector. Connect the console wire to the Reed Switch Wire (4). Slide the Handlebar Post (19) into the Frame (13), making sure not to pinch any of the wires or cables. Attach the Handlebar Post with three M10 x 22mm Button Screws (55) and three M10 Lock Washers (61). 2 19 2a 6 43 Sheath 74 61 Console Wire 4 55 43 Insert Here 61 55 13 6 Tip Sheath 3. Attach the Handlebar (18) to the Handlebar Post 3 (19) with two M10 x 22mm Button Screws (55) and two M10 Lock Washers (61). 55 61 18 19 4. Make sure that there are Adjustable Endcaps (25) on the ends of the Front Stabiliser (27). Hold the Front Stabiliser (27) against the saddle on the front of the Frame (13). Make sure that the Front Stabiliser is turned so the Wheels (26) are not touching the floor. The Wheels should touch the floor only when the exercise bike is tipped for moving. Attach the Front Stabiliser with two M10 x 75mm Carriage Bolts (54) and two M10 Nylon Locknuts (44). 5. Make sure that there are Round Endcaps (15) on the ends of the Rear Stabiliser (16). Hold the Rear Stabiliser (16) against the saddle on the rear of the Frame (13), with the square holes facing away from the saddle. Attach the Rear Stabiliser with two M10 x 75mm Carriage Bolts (54) and two M10 Nylon Locknuts (44). 4 54 27 26 25 26 25 13 44 5 15 44 13 15 16 Square Holes 54 6