ProForm Crosswalk 400e Treadmill User Manual - Page 7
Attach the Right Handrail with two Handrail Bolts 37 - console
View all ProForm Crosswalk 400e Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
2. Attach a Wheel (66) to the base of the Uprights (69) with 2 a Wheel Bolt (64) and a Nut (13) as shown. Do not overtighten the Bolt; the Wheel should turn freely. With the help of a second person, carefully tip the treadmill onto its other side. See assembly step 1, and attach the other Extension Leg (63) and the remaining two Base Pads (57). Then, attach the other Wheel (66) as described above. With the help of a second person, carefully lower the base of the Uprights (69) to the floor so the Uprights are in a vertical position. 64 69 66 13 3. If there is a board between the Uprights (69), remove the board and the two bolts. Discard the board and the bolts. Identify the Right Handrail (72), which has a large hole in the left side. Remove the wire tie securing the Upright Wire (42) inside of the right Upright (69). Feed the Upright Wire into the hole in the bottom of the Right Handrail and out of the large hole in the side. Note: It may be helpful to use needlenose pliers to pull the Wire Harness out of the hole. Set the Right Handrail (72) on the right Upright (69). Attach the Right Handrail with two Handrail Bolts (37) and two Handrail Star Washers (95). Be careful not to pinch the Upright Wire (42). Attach the Left Handrail (71) as described above. Note: There is not an upright wire on the left side. 4. Hold the Console Base (47) near the Left Handrail (71). Attach the end of the ground wire on the Console Base to the indicated small hole in the Left Handrail with the Silver Ground Screw (75). 3 37 95 71 95 37 Hole 69 42 95 72 69 4 Ground Wire 47 Small Hole 75 71 7