ProForm Crosswalk 415 Treadmill English Manual - Page 20

PROBLEM, The crosswalk arms squeak during use, SOLUTION, thin layer - problems

Get ProForm Crosswalk 415 Treadmill PDF manuals and user guides View all ProForm Crosswalk 415 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

PROBLEM: The crosswalk arms squeak during use SOLUTION: a. (Note: Correcting this problem requires a small amount of white marine grease, available at hardware stores.) Turn the Resistance Knob (A) counterclockwise and remove it. Next, remove the Resistance Cone (B) and the Crosswalk Arm (76), along with the Resistance Plate (C), Washers (D), Spring Washer (E), Thrust Washers (F), and Thrust Bearing (G). (Note: If the Resistance Plate [C] comes out of the Resistance Cone [B], press it back in.) Apply a thin layer of white marine grease to the outer surface of the Resistance Cone (B). Then, reattach all parts in the order shown at the right. 76 B F EA C G D 20

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
20
PROBLEM:
The crosswalk arms squeak during use
SOLUTION:
a. (Note: Correcting this problem requires a small
amount of white marine grease, available at hard-
ware stores.) Turn the Resistance Knob (A) coun-
terclockwise and remove it. Next, remove the
Resistance Cone (B) and the Crosswalk Arm (76),
along with the Resistance Plate (C), Washers (D),
Spring Washer (E), Thrust Washers (F), and Thrust
Bearing (G). (Note: If the Resistance Plate [C]
comes out of the Resistance Cone [B], press it back
in.) Apply a
thin layer
of white marine grease to the
outer surface of the Resistance Cone (B). Then,
reattach all parts in the order shown at the right.
B
76
A
F
E
C
G
D