ProForm E35s English Manual - Page 6

ASSEMBLY Assembly requires two people. Set the treadmill in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench and your own 7/16" and 9/16" wrenches , rubber mallet , wire cutters , and Phillips screwdriver. Use the part chart attached in the center of this manual to identify small parts used in assembly. 1. With the help of another person, carefully tip the treadmill onto its left side. Have the other person continue to hold the treadmill during steps 1 through 4. Identify the Right Upright (58), which contains the Wire Harness (55). Insert the round tube on the Right Upright into the Base (117) as shown. If necessary, apply grease to the round tube and use a rubber mallet. Hold a Star Washer (113) between the indicated tab and the base, and Finger tighten an Upright Bolt (66) through the tab into the Base. Make sure that the two Walking Platform Screws (114) in the right and left sides of the Walking Platform (100) are tight. 2. Attach a Base Leg (78) to the Base (117) with two Base Leg Bolts (77) and two Base Leg Nuts (70). Make sure that the Base Pad (75) is in the position shown. (Note: The Base Leg Nuts fit into square holes in the Base. If necessary, push or pull on the Right Upright [58] to align the holes.) Do not fully tighten the Base Leg Bolts until step 6 is completed. 1 66 Tab 113 117 2 77 66 75 78 77 70 117 55 58 58 100 114 3. See the inset drawing. Identify the right Front Wheel (62) by observing the direction that the Wheel Bracket (64) 3 62 slants. Attach the Wheel Bracket (64) on the right Front Wheel (62) to the Base (117) with four 3/4" Screws (65) as shown. Attach a Thin Base Pad (103) and a Thick Base Pad (75) to the Base (117) with two 3/4" Screws (65) as shown. 117 103 64 65 62 Right Left 65 75 64 6