ProForm Endurance 920 E Elliptical English Manual - Page 37
See Exploded Drawing C
View all ProForm Endurance 920 E Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
See the lower drawing on page 36. Plug in the power cord, press the power switch to the reset position, and rock the Pulley (19) forward and backward just enough that the Magnet (43) passes the Reed Switch (38) repeatedly. See EXPLODED DRAWING C on page 43. Identify the Left and Right Shields (73, 74). Remove the M4 x 19mm Screws (5) and the M4 x 48mm Screw (107) from the Left and Right Shields. Then, remove the Right Shield. Repeat these actions until the console displays correct feedback. When the reed switch is correctly adjusted, press the power switch to the off position, unplug the power cord, and reattach the left disc. Next, locate and loosen the Idler Screw (89). Tighten the Belt Adjustment Screw (91) until the Drive Belt (113) is tight. Then, retighten the Idler Screw. HOW TO ADJUST THE DRIVE BELT If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest level, the drive belt may need to be adjusted. 113 To adjust the drive belt, first press the power switch to the off position and unplug the power cord. See assembly step 16 on page 16. Use a standard screwdriver to remove the Shield Cover (75) and the Shield Cover Cap (118). See assembly step 15 on page 16. Remove the Right Upper Body Leg Outer and Inner Covers (69, 83). See assembly step 12 on page 14. Remove the Right Pedal Arm (58) from the Right Upper Body Leg (60). 89 91 Reattach the right shield, the right roller arm, the right pedal arm, the shield cover cap, and the shield cover. Then, plug in the power cord. Next, remove the M8 x 16mm Screw (95), the Large Axle Cover (53), and the M8 Washer (not shown) from the right Crank Arm (20). Then, carefully remove the Right Pedal Arm (58) and the Right Roller Arm (59) from the elliptical. 20 53 59 95 58 37