ProForm Perspective 1.0 Lx Treadmill English Manual - Page 10
in the location
View all ProForm Perspective 1.0 Lx Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
8. Note the location of the 75 ohm antenna terminal on the 8 treadmill. For the television to operate properly, an an- tenna, a CATV cable, or a VCR must be connected to the 75 ohm antenna terminal (see page 11). 75 Ohm Antenna Terminal 9. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. Note: Extra hardware may be included. Keep the included allen wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 27). If you purchase the optional chest pulse sensor (see page 23), follow the steps below to install the receiver included with the chest pulse sensor. 1. Make sure that the key is removed from the console and that the power cord is unplugged. Remove the indicated Screws (3) from the back of the Console Base (85). 2. Connect the wire on the receiver (A) to the indicated wire on the Console (34). Hold the receiver so the small cylinder is oriented as shown. Next, remove the tape from the back of the receiver, and press the receiver onto the Console Base (85) in the location shown. 34 Small Cylinder A Wire 3 85 3 3. Make sure that no wires are pinched. Reattach the Console (34) with the Screws (3). Discard the other wires included with the receiver. 3 3 10