ProForm Premier 1300 Treadmill Uk Manual - Page 33

SYMPTOM: The iFit mode does not function correctly a. If the iFit mode is not functioning correctly, make sure that the treadmill has the most current firmware available (see step 3 on page 27). SYMPTOM: The incline of the treadmill does not change correctly a.  Calibrate the incline system (see step 4 on page 27). Locate the Reed Switch (110) and the Magnet (109) on the left side of the Pulley (49). Turn the Pulley until the Magnet is aligned with the Reed Switch. Make sure that the gap between the Magnet and the Reed Switch is about 1/8 in. (3 mm). If necessary, loosen the #8 x 3/4" Truss Head Screw (14), move the Reed Switch slightly, and then retighten the Truss Head Screw. Reattach the Motor Hood (not shown) with the #8 x 3/4" Screws (not shown) and run the treadmill for a few minutes to check for a correct speed reading. SYMPTOM: The treadmill will not connect to the wireless network Top a. Make sure that the wireless settings on the console are correct (see page 28). View 110 14 1/8 in. 49 109 b. Make sure that the settings for your wireless network are correct. c. If you still have questions, see the front cover of this manual. SYMPTOM: The displays of the console do not function properly SYMPTOM: The walking belt slows when walked on a. If an extension cord is needed, use only a 3-conductor, 14-gauge (1 mm2) cord that is no longer than 5 ft. (1.5 m). a. Remove the key from the console and UNPLUG THE POWER CORD. Remove the five #8 x 3/4" Screws (2). Carefully pivot off the Motor Hood (65). a 2 65 2 2 b. If the walking belt is overtightened, treadmill performance may decrease and the walking belt may become damaged. Remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both idler roller screws counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is properly tightened. b 2-3 in. Idler Roller Screws 33