ProForm Restoration 2.0 English Manual - Page 15
Opening And Closing The Cut-off Valves
![]() |
View all ProForm Restoration 2.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
2. Unplug the power cord. 3. Remove the access cover from the back of the spa unit. 4. Remove the drainage hose from the clip and attach a garden hose to the valve on the drainage hose. Cut-off Valve Cut-off Valve Valve Drain Hose Knob 5. Open the valve by turning the knob counterclockwise. The water will begin to drain. 6. When the spa is empty, close the valve and remove the garden hose. Return the drainage hose to the clip and replace the access cover. 7. Refill the spa and treat the water with chemicals (see pages 13 and 14). DRAINING THE PUMP After the RESTORATION 2.0 is drained (see DRAINING THE RESTORATION 2.0 above), the pump in the spa jet unit should also be drained if the RESTORATION 2.0 will be stored for more than thirty days, or if it may be exposed to freezing temperatures. To drain the pump, remove the access cover from the spa unit (see ATTACHING Pump AND REMOVING THE ACCESS COVER on the next page). Locate the pump inside the spa Drain Plug unit. Remove the drain plug from the pump. Tip the spa jet unit slightly, until all the water has drained from the pump. Replace the drain plug. OPENING AND CLOSING THE CUT-OFF VALVES For minor repairs to the pump/motor, the cut-off valves can be closed. To close the valves, remove the access cover from the back of the spa unit. Locate both cut-off valves. Push the handles into the closed position and turn the handles until they lock into place. If you are planning to work on the pump/motor, you will also need to drain the pump (see page 14). To open the valves, turn the handles until they are unlocked, and pull the handles out to the open position. WINTER USE AND CARE The RESTORATION 2.0 is designed for year-round use. If you decide to store the RESTORATION 2.0 for the winter, store it in a warm, dry location. Follow the steps below to winterize the RESTORATION 2.0. 1. Drain the spa (see DRAINING THE RESTORA- TION 2.0 on page 14). 2. Remove all remaining water from the spa shell. Dry the spa shell with towels. 3. Set the air control on the console to the lowest setting. Use a wet/dry vacuum to pull any remaining water from the system. To do this, place the vacuum nozzle over each thera-jet, starting with the highest jet and finishing with the lowest one. 4. Set the air control on the console to the highest setting and repeat step 3. 5. Drain the pump (see DRAINING THE PUMP on page 14). Once the water has drained from the pump, place the vacuum nozzle over the drainage hole in the pump and vacuum any additional water from the pump. Note: For additional protection you can remove the pump/motor from the spa to store it in a climate controlled room. 6. Clean the spa shell (see page 13). 7. Clean the filter (see page 13). 8. Re-attach the access cover. 9. Re-attach the spa cover. 15
![](/manual_guide/products/proform-restoration-20-english-manual-1ed5375/15.png)