ProForm Smart Strider 695 Cse Instruction Manual - Page 6

ASSEMBLY • Assembly requires two persons. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps. • In addition to the included tool(s), assembly requires the following tool(s): one Phillips screwdriver Assembly may be easier if you have a set of wrenches. To avoid damaging parts, do not use power tools. 1. To register your product and activate your warranty in the UK, go to iconsupport.eu. If 1 you do not have internet access, call Customer Service (see the front cover of this manual).  To register your product and activate your warranty in Australia, email or post the following information to the email address or postal address on the front cover of this manual. • your receipt (make sure to keep a copy) • your name, address, and telephone number • the model number, serial number, and name of your product (see the front cover of this manual) 2. With the help of another person, place some sturdy packing materials under the rear of the 2 Frame (1) so that the Frame is lifted off the floor. Have the other person hold the elliptical to prevent it from tipping. If there are shipping supports attached to the rear of the Frame (1), remove the screws attaching the shipping supports. Discard the screws and the shipping supports. Attach the Rear Stabilizer (70) to the Frame (1) with two M10 x 120mm Screws (84). 70 Then, remove the packing materials and lower the elliptical. 1 84 6