ProForm Xp 542s Treadmill English Manual - Page 7
If the Uprights are at the desired
View all ProForm Xp 542s Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
6. If you wish to adjust the height of the Uprights (80, 6 84), go to step 7. If the Uprights are at the desired 84 height, tighten the four Upright Bolts (86) and go to step 8. 86 97 80 97 7. Note: The Uprights (80, 84) can be attached at three dif- 86 ferent heights. The Uprights are preattached in the mid- dle position. Adjusting the Uprights requires two persons. While a second person holds the Console Base (101) and 7 the Uprights (80, 84), loosen the four Upright Bolts (86). Then, remove the two Upright Bolts and Upright Star 84 Washers (45) from the Right Upright (80). Raise or lower the Right Upright to the desired height, being careful not to damage the Wire Harness (74). If the Upright Spacer 45 (79) falls, press it back onto the Upright Base (97). Loosely thread the two Upright Bolts and Upright Star Washers back into the Right Upright and the Upright Base. 101 79 80 Adjust the Left Upright (84) in the same way. (Note: There are no wires in the Left Upright.) Make sure that both Uprights are at the same height. Lift the Walking Platform (13) and make sure that it is centered between the Uprights. Then, retighten all four Upright Bolts (86). 86 13 74 79 45 97 86 8. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the walking belt (see page 23). To protect the floor or carpet, place a mat under the treadmill. If you purchase the optional chest pulse sensor (see page 20), follow the steps below to install the receiver included with the chest pulse sensor. 1. Make sure that the power cord is unplugged. Remove the indicated Screw (108) and the Access Door (96). 2. Remove the paper from the adhesive pad on the back of the receiver (A). Orient the receiver so the small cylinder is near the lower edge of the receiver and is facing the Console (107) as shown. Firmly press the receiver onto the indicated corner of the Access Door (96). Connect the wire on the receiver to the indicated wire extending from the Console. 3. Make sure that no wires are pinched. Reattach the Access Door (96) with the Screw (108). Note: The wires included with the receiver may be discarded. 107 Wire A Wire Cylinder 96 108 7