ProForm Xp Crosswalk 580 Treadmill English Manual - Page 12

15. Remove the Resistance Knob (88) from a resistance assembly. Make sure that the 3/8" x 4 15 3/4" Bolt (90) stays inside of the resistance assembly and that the resistance assembly does not come apart. Note: See the lower drawing to reassemble the resistance assembly if necessary. 88 Apply a small amount of the included grease around the Resistance Cone (85). Insert the Resistance Cone into the Upright Insert (84) in the Left Upright (77), with the two large holes on top as shown. Then, tighten the Resistance Knob (88) onto the 3/8" x 4 3/4" Bolt (90). Attach the other resistance assembly to the Right Upright (92) in the same way. 88 77 Large 84 Holes 92 85 Resistance Assembly 90 84 Large Holes 85 90 16. Insert the end of a Crosswalk Arm (82) into the hole in the top of a resistance assembly. Make sure that the bend in the Crosswalk Arm is positioned as shown. Tighten the #8 x 3/4" Screw (1) into the resistance assembly and Crosswalk Arm (82) from the direction shown. Press a Small Cap (89) into the hole for the Screw. Attach the other Crosswalk Arm (82) in the same way. 16 Bend 82 Hole Resistance Assembly 89 1 Bend 82 1 89 12