Pyle AZPLMRA830BT User Guide - Page 2
Testing & Connections, Maintenance
View all Pyle AZPLMRA830BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Testing & Connections After all the connections have been made. turn on your stereo and listen for the amplifier to turn on. If there are any unusual noises from the speakers then turn the system off and recheck all the wiring. After you have connected your radio or equalizer to the amplifier, you may adjust the gain control to match the output level of your radio: (A) Set the volume control on your radio to 2/3 position. (B) Adjust the gain control for an average listening level. (C) Turn the radio volume all the way down and listen for background noise. (D) Start your vehicle and listen for electrical noise. (E) Making fine adjustments to the sensitivity can reduce background noise and some engine noise. (F) CAUTION: Never turn the sensitivity up any farther than you need to get clear sound at 2/ 3 volume. (G) This adjustment only needs to be made once. NOTE: CARE MUST BE TAKEN AGAINST BATTERY OVER-DISCHARGE CAUSED BY LONG OPERATION Of THE SET AT A HIGH SOUND LEVEL WHEN THE ENGINE IS NOT RUNNING OR IDLING. Maintenance Keep the amplifier dry. If it gets wet, wipe it dry immediately. liquids can contain minerals that corrode electronic circuits. Use the amplifier only in normal temperature environments. Temperature extremes of heat or cold can shorten the life of electronic devices and distort or melt plastic parts. Handle the amplifier gently and carefully. Dropping it can damage circuit boards and cases and can cause the amplifier to work improperly. Keep the amplifier away from dust and dirt. which can cause premature wear of parts. Wipe the amplifier with a damp cloth occasionally to keep it looking new. Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the amplifier. After all the connections have been made. turn on your stereo and listen for the amplifier to turn on. If there are any unusual noises from the speakers then turn the system off and recheck all the wiring. Elite Series Waterproof Amplifiers