Pyle HTG559BT Instruction Manual - Page 7

CONTROL FUNCTIONS 1. RCA Input jacks These RCA input jacks are for use with source units that have RCA or Line level outputs. A source unit with a minimum level of 200mV is required for proper operation. The use of high quality twisted pair cables is recommended to decrease the possibility of radiated noise entering the system. 2. GAIN Control The level control will match the ampli ers sensitivity to the source units signal voltage. The Operating range is 200mV minimum to 6V maximum. CAUTION: Do not run the ampli er in high volume for long time, otherwise the loudspeakers will be damaged. 3. X-OVER (SELECT) • Full pass x-over switch When the switch is in the "FuII" position, the full range is bypassed. • Low pass x-over switch When the switch is in the "LPF" position, frequencies lower than the low pass frequency setting are passed. The frequency can be adjusted between 40Hz and 250Hz. • High pass x-over switch When the switch is in the "HPF" position, frequencies higher than the high pass frequency setting are passed. The frequency is 40Hz-250Hz • Band Pass select switch When the switch is in the "Band Pass" position, the band pass range is by passed: 50Hz-2.5KHz. 4. Bass BOOST The boost can be selected among 0dB, 6dB and 12dB. 5. Wireless BT Streaming Wireless BT receiver. Warning: Do not connect a level control knob from other manufacturers to the Remote Sub Level Control of any ampli er. Even though the connectors t properly, the control knob and connector pin positions may be di erent and the ampli er will be damaged. www.Lanzar.com 7