Pyle NCIT2S Instruction Manual - Page 6

Troubleshooting and Treatment During operations, if there is any error, please check the following table for common troubleshooting options before calling for service. Below are common errors and the checks to perform ERROR SCENARIO CHECK POINTS After connecting the power and pressing the "Power" key, the appliance has no response Is there power supply in the outlet? Is there plug connected rmly? Is the fuse broken down? REMEDY Use after resuming the electricity Check the root cause carefully. If the problem can't be xed, please contact service center for checking and repairs. Has a cookware been placed on the Place cookware. Check if the Induction Cooker sends out surface? Is the cookware induction cookware is induction "Beep" Sound compatible? compatible. Is the cookware placed on the center of the heating zone? Place the cookware at the center of de ned heating zone Is the cookware bigger than 12cm? Use cookware with diameter within 12-26cm No Operation during the heating being in use Is the cookware empty or the temperature too high? Is the air intake/exhaust vent clogged or dirt has accumulated Please check whether the appliance is being misused Remove the dirt clogging the air intake/exhaust vent. Operate the appliance again after cooling down. Is the cooker working over 2 hours Reset cooking modes or use without any external instruction? timer function Error codes occur E0 Error codes occur E1 Error codes occur E2 Error codes occur E3 Error codes occur E4 Error codes occur E5 Error codes occur E6 Without Cookware or Incompatible When showing error signal cookware used E0, E3, E5, please check Low-Voltage whether the cookware is induction compatible or not? High-Voltage Or switch on the appliance Top plate Overheat again after it is cooled down naturally. When Show E1, E2, Top Plate Sensor Open Circuit E4, E6, please contact service IGBT Overheat Top Plate Sensor Short Circuit center for checking and repairs 6 www.NutrichefKitchen.com