Pyle PAMP2000BT User Manual - Page 5

Speaker A/B Binding Post Terminals - manual

Get Pyle PAMP2000BT PDF manuals and user guides View all Pyle PAMP2000BT manuals
Add to My Manuals
Save this manual to your list of manuals

Page 5 highlights

input mode to provide over 160 watts RMS mono output. For mono application use only the R+ and L- of SPEAKER A channel output. Please preset the volume control at MIN and adjust to the desired level. 11. Auto On Switch Lets you select AUTO position to activate the amp automatically when the signal is sent to input source, the amp will shut down automatically after a period of time without the signal source is sent, please preset the Power On/Off switch to ON position in this application. Select NORMAL position to activate the amp manually by pushing On/Off Power Button. 12. Speaker A/B Binding Post Terminals Let you to connect two stereo pairs of speakers via the wire terminals. 13. Voltage Switch This amplifier has selectable input voltage from 110V/60Hz (the standard in USA and CANADA) to 220V/50Hz (for EUROPEAN operation). Please make sure the switch is in the proper position before operating, otherwise severe damage will be incurred and not covered by the warranty. 14. AC Outlet ( Un-switched ) Supply power (maximum load of 200W) to a musical instrument or another amplifier. 15. AC Input Plug the included power cord into the unit first while the power is switched off, and then plug the AC power cord into a proper power outlet. Please also replace the fuse only with proper rating if needed (see the fuse rating of T4AL 250V for 110-120V and T2AL 250V for 220-240V printed at power inlet). 16. Fuse Holder To change the fuse, put the main plug out from the main outlet and open the fuse holder with a screwdriver.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
input mode to provide over 160 watts RMS mono output. For mono application use only the
R+ and L- of SPEAKER A channel output. Please preset the volume control at MIN and
adjust to the desired level.
11.
Auto On Switch
Lets you select AUTO position to activate the amp automatically when the signal is sent to
input source, the amp will shut down automatically after a period of time without the signal
source is sent, please preset the Power On/Off switch to ON position in this application.
Select NORMAL position to activate the amp manually by pushing On/Off Power Button.
12.
Speaker A/B Binding Post Terminals
Let you to connect two stereo pairs of speakers via the wire terminals.
13.
Voltage Switch
This amplifier has selectable input voltage from 110V/60Hz (the standard in USA and
CANADA) to 220V/50Hz (for EUROPEAN operation). Please make sure the switch is in
the proper position before operating, otherwise severe damage will be incurred and not
covered by the warranty.
14.
AC Outlet ( Un-switched )
Supply power (maximum load of 200W) to a musical instrument or another amplifier.
15.
AC Input
Plug the included power cord into the unit first while the power is switched off, and then
plug the AC power cord into a proper power outlet. Please also replace the fuse only with
proper rating if needed (see the fuse rating of T4AL 250V for 110-120V and T2AL 250V for
220-240V printed at power inlet).
16.
Fuse Holder
To change the fuse, put the main plug out from the main outlet and open the fuse holder with
a screwdriver.