Pyle PB918 Instruction Manual - Page 10

FUNCTIONS (PB718/PB918/PB2518/PB3818) 1. HIGH LEVEL INPUT(LOW IMPEDANCE) If your car stereo does not have RCA output jacks, you can connect the speaker output from the stereo system to the amplifier. 2. LOW LEVEL INPUT(HIGH IMPEDANCE) This unit is provided with RCA input jacks for High impedance input. Couple the RCA input with the car stereo output using RCA type connector cables. 3. AUX LINE OUTOUT This amp features RCA jacks or AUX line output. 4. INPUT LEVEL CONTROL Adjusting the control will match the output of the stereo to the amplifier. Turn the control clockwise for more volume and counter-clockwise for less volume if there is distortion when the volume of stereo is turned up, turn the control down. 5. BASS BOOST CONTROL The Bass-Boost dial increases the bass signal to the speaker. 6. LOW PASS CONTROL The LPF 50Hz/250Hz lets you adjust the crossover frequency from 50Hz to 250Hz, this control is useful only for subwoofers and not you main speakers. 7. HIGH PASS CONTROL The HPF 120Hz/3kHz lets you adjust the crossover frequency from 120Hz to 3kHz, lets you set the tweeter speakers. 8. FULL/LPF/HPF CROSSOVER SWITCH For use with normal full range systems, this selector should be set to the FULL position. If this AMPLIFIER is being utilized to power a CROSSOVER system, this selector should be set to either the HPF (H IGH PASS FILTER) or LPF (LOW PASS F ILTER) position to enable the built-in electronic crossover. 9. POWER ON LED Lights up when the remote on system is energized, 10