Pyle PBT30M PBT30M Manual 1 - Page 2

A B C D 8 ● Led Status LED Status 1 x 3 sec. Blue Ready can be accessed by paired devices 1 x 1 sec. Blue Talking Blinking red Battery low (max. 15 Minutes left) Red LED on Under charging Red LED off Fully charged Red/Blue Blinking Pairing-Mode 7 Reminding: - For safety reason, please don't leave the headset in car alone when charging. - When the battery is low, the LED will not turn on until the headset is charged up, which may take several minutes. 7 Sound Around Inc. PBT30M 11 USB Dongle and PBT30M Bluetooth Headset Voice Over Internet Protocol (VoIP) Application  Install Software for Bluetooth USB Dongle from the CD-ROM provided in the USB Dongle package. Note that the CD-ROM is not available in the PBT30M package.  Plug the USB Bluetooth Dongle (purchased separately) into the USB socket of a PC.  Download from the corresponding websites and install Skype, MSN messenger,Netmeeting, Yahoo messenger, or ICQ application software in the PC. 6  Pairing: Put the PBT30M Bluetooth Headset into "pairing" mode. Start the Bluetooth software and pair the USB Dongle with the PBT30M Headset. The Headset passkey is "0000".  Connecting and Disconnecting: To connect the USB dongle, press the S1 key on the Headset. To disconnect the Bluetooth link, press the S1 key again.After turn off and turn on the headset, The following company is responsible for this declaration: you just need to press S1 key to establish the audio link with USB dongle if the USB dongle is the last used device. Sound Around Inc.  Testing the Bluetooth Link: After the USB Dongle is connect with the PBT30M Headset, the PC audio will be automatically routed to the "Bluetooth Audio" driver. Play some music on the PC by Windows Media Player or other music applications; you should be able to hear the music on the Headset. If you can't hear it, then go the "control Panel " ->" Sound and Audio Device 1600 63rd Street Brooklyn N.Y. 11204, USA Properties"-> "Audio"-> "Sound playback" select the "Bluetooth Audio" to activate the link.  Now you can start using the VoIP application and talk to your friend through your Headset wirelessly and freely. Phone: 1-800-444-5671 718-535-1800 Fax: 718-236-2400  Connecting PBT30M Bluetooth Headset back to your Bluetooth mobile phone. Please follow Bluetooth Qualified Design ID: B013218 the steps from 'Headset in Pairing Mode' to 'Establishing Bluetooth Link'. 8 12 Federal Communication Commission 5 Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 4 9 FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. FCC ID:NV6-CS8127 3 Environmental friendly 10 2 E 8 7 6 5 4 3 2 Note Material: 80g Woodfree Paper PART NO.: MODEL: MCB-8127020-1A 8127 In-Tech Electronics Ltd. 1 1 DRAWN: DATE: DESCRIPTION: Limingzan PAPER SIZE: UNIT: 20071204 SCALE: #User Manual For PYLE Logo A3 MM 1:1 A B C D E