Pyle PCT40 Instruction Manual - Page 1
Pyle PCT40 Manual
![]() |
View all Pyle PCT40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Cab/e testing: At first, turn the rotary switch fully clockwise to test the battery strength. The battery LED will light bright green if the internal battery is fully charged. Then plug one one end of the cable into the appropriate jack on the left side panel of the cable tester. Plug the other end of the cable into the appropriate jack on the right side panel. Set the rotary switch to"l" to test the connection of contact l on the plug inserted in to the left side panel. If there is a connection, the Green LED willlight below "1" and a YELLOW LED will light above each contact on the right side plug connected to "l" on the left side plug. Use the charts below verify proper cable connections. If no LED lights than there is no connection and the left side contact "1" is "floating," due to design or an "open" in the cable. Set the rotary switch to "2" to test contact 2, and so on, until all contacts have been checked. If the Ground LED lights than there is a connection between the corresponding contacts and the chassis. To test the cable with a banana plug, just plug each end of the cable into the banana jacks: The LED will light and the unit will beep a tone if there is connection between the plugs. These banana jacks can also be used for continuity tests using two probe leads. Jack 1 = sleeve 2 =tip 3 = ring Speakon l = -1 5 = -3 2 = +1 6 = -3 3 = -2 7 = -4 4 = +2 8 =+4 Phono 1 screen 2 = hot 1/4" TS Mono to 1/4" Mono 1 Sleeve 1 Sleeve, 3 Ring XLR unbalanced to XLR unbalanced Pin 1 Pin 1, Pin 3 2 Tip 2 Tip Pin 2 Pin 2 3 Ring 1 Sleeve, 3 Ring ( Shorted with sleeve) 1 / 4" TRS to 1/4" TRS 1 Sleeve 1 Sleeve 2 Tip 2 Tip 3 Ring 3 Ring Pin 3 Pin 1, Pin 3 1/4" TS Mono to XLR unbalanced 1 Sleeve Pin 1, Pin 3 2 Tip Pin 2 3 Ring Pin 1, Pin 3 (shorted with sleeve) XLR balanced to XLR balanced Pin 1 Pin 1 Pin 2 Pin 2 Pin 3 Pin 3 1/4" TRS to XLR balanced 1 Sleeve Pin 1 2 Tip Pin 2 3 Ring Pin 3 Features: Enables quick convenient continuity cable testing for all types of cables LED's confirm each conductor continuity and connection. 10 -way switch for selecting connections to be tested. Also includes internal battery and ground connection status checks. Rugged, compact, metal construction for ultimate roadworthiness, long life, and reliability. Tests cables with all types of combinations of the following connectors: * USB * 3. 5mm Jacks * 6. 35mm Jacks * 3-PIN XLR * 5-PIN XLR * RCA/Phono * 3-PIN DIN * 5- PIN DIN * 8- PIN DIN * 4-PIN S Type Jack * RJ45 * 4-PIN SPEAKER * 8 PIN SPEAKER * 9V Alkaline Battery
![](/manual_guide/products/pyle-pct40-instruction-manual-870fe60/1.png)