Pyle PDJLT50 Instruction Manual - Page 2

1. SAFETY INSTRUCTION WARNING Please read carefully the instruction, which includes important information about the installation, usage and maintenance • Please keep this User Manual for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet • Unpack and check carefully if there is no transportation damage before using the unit. • Before operating,ensure that the voltage and frequency of power supply match the power requirements of the unit • It's important to ground the yellow/green conductor to earth in order to avoid electric shock. • The unit is for indoor use only. Use only in a dry location • The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent surfaces. Be sure that no ventilation slots are blocked • Disconnect main power before replacement or servicing. • Make sure there is no ammable materials close to the unit while operating as it is re hazard. • Use safety cable when xing this unit. Don't handle the unit by holding its head only, always hold it by its base or body. • Maximum ambient temperature is at:104°F. Don't operate where the temperature is higher than 104°F. • Unit surface temperature may reach up to 185°F. Dont touch the housing bare-hand during its operation. Turn o the power and allow 15 minutes for the unit to cool down before replacing or serving. • In the event of serious operating problem, stop using the unit immediately. Never try to repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the nearest authorized technical assistance center. Always use the same type of spare parts. WARNING • To prevent or reduce the risk of electrical shock or re, do not expose the unit in the rain or moisture. • Do not open the unit within ve minutes after switching o . • The housing, the lenses, or the ultraviolet lter must be replaced if they are visibly damaged. 1 www.PyleUSA.com 3. CAUTION There are no user serviceable parts inside the unit. Do not open the housing or attempt any repairs by yourself. In the unlikely event your unit may require service, please contact your nearest dealer. 4. INSTALLATION The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is rmly xed to avoid vibration and slipping while operating. Make sure that the structure to which you are attaching the unit is secured and able to support a weight of 10 times of the unit's weight. Always use a safety cable that can hold 12 times of the weight of the unit when installing the xture. The equipment must be xed by professionals. The PDJLT50 must be xed at a place where it is out of touch of people and no one can pass by or under it. • DISPLAY To show the various menus and the selected functions • LED DMX On DMX input Present MASTER On Master Mode SLAVE On Slave Mode SOUND Flashing Sound activation • Button MENU DOWN UP ENTER To select the programming functions To go backward in the selected functions To go forward in the selected functions To con rm the selected functions • MAINS INPUT Connect to power supply. • MAINS OUTPUT Connect to supply power to the next unit • DMX INPUT / OUTPUT For DMX512 link, use 3/5-pin XLR cable to link the unit together. 2 www.PyleUSA.com