Pyle PDT35 PDT35 Manual 1 - Page 2

Replacing the Batteries

Page 2 highlights

EMC Regulations: EN50081-1, EN50082-1 Polarity: Automatic, (-) negative polarity indication. Over-range: "1" mark indication Low battery indication: The "BAT" is displayed when the battery voltage drops below the operating level. Measurement rate: 2 times per second, nominal Continuity test: Audible threshold 0 -10K, Continuity beeper 2KHz Input Impedance: 400K Temperature: Operating:-10℃ to +50℃(14oF to 22oF), Storage:-30℃ to +60℃ Altitude: Operating: 3,000m; Storage: 10,000m Relative Humidity: 90%(0℃-30℃);75%(30℃-40℃); 45%(40℃-50℃) Battery Type: AA (2); NEDA 15F or IEC R6 Replacing the Batteries If the sign "BAT" appears on the LCD, it indicates that the batteries should be replaced. Remove screws on the back cover and open the case. Replace the exhausted batteries with new batteries. (AA (2); NEDA 15F or IEC R6) Disconnect probes from Voltage 2xAA Do not over-tighten screws www.pyleaudio.com

  • 1
  • 2

EMC Regulations
: EN50081-1, EN50082-1
Polarity
: Automatic, (-) negative polarity indication.
Over-range
: “1” mark indication
Low battery indication
: The “BAT” is displayed when the battery voltage
drops below the operating level.
Measurement rate
: 2 times per second, nominal
Continuity test
: Audible threshold 0 -10K
, Continuity beeper 2KHz
Input Impedance
: 400K
Temperature:
Operating:-10
to +50
(14
o
F to 22
o
F),
Storage:-30
to +60
Altitude:
Operating: 3,000m; Storage: 10,000m
Relative Humidity:
90%(0
-30
);75%(30
-40
); 45%(40
-50
)
Battery Type
: AA (2); NEDA 15F or IEC R6
Replacing the Batteries
If the sign “BAT” appears on the LCD, it indicates that the batteries should be
replaced. Remove screws on the back cover and open the case. Replace the
exhausted batteries with new batteries. (AA (2); NEDA 15F or IEC R6)
2xAA
Disconnect probes
Do not
from Voltage
over-tighten screws
www.pyleaudio.com