Pyle PICKIT20 Instruction Manual - Page 2
Step 3 Connecting, Step 4 Printing in the App, Power and active status, Battery Status,
View all Pyle PICKIT20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Step 3 Connecting www.PyleUSA.com 1. WiFi Access Point (AP) *Apple and Android Devices. 1. Turn WiFi on in your smartphone. 2. Go to WiFi setting and find "Direct-Cube-XXXX". * Printer names are vary and 4 digits. The 4 digits are combination of number and alphabet. 3. Password is "12345678". 4. Select the WiFi network to connect the printer. 2. NFC and WiFi Direct *NFC. WiFi Direct support devices ONLY 1. Turn NFC and WiFi on in your smartphone. *Set the NFC setting as P2P mode. 2. Tap your device on the center of the printer where the NFC mark is. 3. Within 20 seconds, the app will automatically connect to WiFi Direct 4. When the printer is connected to WiFi Direct, green mark will be shown in the app. Step 4 Printing in the App www.PyleUSA.com Power and active status www.PyleUSA.com Status Power ON Power OFF (2sec) Printing F/W Upgrade No Cartridge Error (Paper Jam, etc.) Waiting/Cooling Battery Status White O White Flickering Pink Flickering Red Flickering Red Flickering White Status Charging Charging Complete Red Green Troubleshooting Symptom CAUSE / SOLUTION Paper Jam Power OFF and Power ON again. Paper will be automatically ejected. If not, please contact customer service. Image quality Print quality could be less if your photo source has low resolution. is not good Over 1280 x 2448 pixel is recommendedfor best image quality Printer is not responding Press Reset button with sharp tool like pin. Step 6 Note and FCC Note • Photo Paper will go in and out 4 times (YMCO, Yellow. Magenta. Cyan, Overcoating). Do NOT touch the paper during printing process for best image quality. • Do not pull paper out by force during printing. • Do not place an object in front of the paper exit slot. • Use the latest Pickit application for law print quality. Check the latest app version from Google Play Store and Apple Appstore. • Printer has Built-In Battery. Charge the printer before using. • Handle with care during charging to prevent electric shock. • Do not disassemble or deform. • Avoid too high or low temperature or humidity. • If NFC tag is not read, check its position on the printer and smartphone. Then try again. • The higher resolution the image has, the higher quality the printed photo has. Recommended image size is 1280 * 2448 pixel. • Operating Temperature: 32~104°F FCC (Federal Communications Commission) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. and 2. This device must accept any Interierence received. including Interierence that may cause undesired operation. CAUTION: Any changes or modi cations to the equipment not expressly approved by the party responsible responsible for compliance could void user's authority to operate the equipment. This device (FCCID: PO5M1) complies with FCC SAR requirement. * In case of multiple printers are available